112002W

2" Diameter Injection Molded White Polypropylene Spigot Termination Screen for Venting System (50 per Carton)

Manufacturer Name: Canplas Industries Ltd.
VAMAC PN: 271212
  • Min. Order Qty: 1
  • Qty. Interval: 1
  • Venting System Termination Screen; Type Termination Screen, Spigot; Used On Venting System; Size 2 Inch Diameter; Material White Durable Injection Molded Polypropylene; Temperature Rating -40 to 180 Deg F (Service); Application Gas Water Heater Exhaust, High Efficiency Furnace Exhaust, High Efficiency Furnace Air Intake, Schedule 40 DWV Fitting

    Type      :      Termination Screen, Spigot
    Used On      :      Venting System
  • Termination Screen Fits Inside Hub End of Schedule 40 DWV Fitting
  • This will not Rust from Acidic Vent Gas
  • More Difficult to Flash Freeze than Metal Screen
  • No Sharp Edges, Unlike Metal Screen
  • Friction Fit
  • Does not Conduct Heat Like Metal, Can be Removed if Necessary
  • Injection Molded in Non-Toxic Durable Polypropylene
  • Normally Used in the Venting Portion of the System Only
  • Normally Used in the Drainage Portion of the DWV System Only
  • Service Temperature Rated at -40 to 180 Deg F
  • Hand Tighten Plus a Half Turn Provides a Complete Seal
  • Non-Stick Tape is Recommended for Threaded Joint
  • Approved for Both Vertical and Horizontal Installation
  • Package Weight      :      1.06
    Package Weight Uom      :      Pound
    Package Quantity      :      1